Quick Lifting
The quick access device enables the slide up 70mm within 60 seconds to help users quickly solve tooling problems.
Guiding System
2 Plungers and 8 gibs
Dual plungers isolate slide from angular front-to-back movement of connections and bear up more upward eccentric load. 8 square long guide gibs and linear bearings are applied to absorb the sideward thrust during stamping
Strong Structure
6 Point of Crank Supporting
The distance between supporting is short to resist deflective stress. 2 bearings and 4 hydro-dynamic brass bushings are applied to get smaller clearance.
Clutch and Brake
Separated Clutch and Brake
The torch of separated clutch & brake is bigger, so braking time and angle get less.
Balanced load at two side can reduces wear of bearings. If mechanical parts fail at clutch or brake, press stops immediately.
B.D.C. Test
Dynamic Accuracy Test
Not only JIS static accuracy checked but dynamic accuracy tests are also our standard procedures.
Start Running at Constant Speed
Press starts cotinuous running. The maximum gap is 0.1mm.
The B.D.C. keeps stable after 30 minutes during running continuously.
Running at Stable Temp. & Constant Speed
After press temp. keeps stable, press keeps running and record the B.D.C positions of 1,000 stamping. The maximum gap is ± 0.005mm